Sat Finder

Digital Satellite Finder
It has a real time spectrum analyzer, AV In & Out and with Xcruiser "Smart Search Function" you can easily find the satellite location, transponder and symbol rate and search and view the the channel on screen at same time.The Satellite Meter is a handy digital antenna measuring device for a quick and easy alignment of satellite antennas. If a satellite is found, the meter shows it on the display and emits a audible signal. Signal strength and quality are displayed as numerical values and bar graphs. Another measurement value is the forward error correction (FEC) and the bit error rate (BER). In addition, the picture quality can be revised on the high-resolution 4.3-inch TFT LCD screen.
Many satellites are pre-programmed in order to a quick antenna adjustment. The scope of supply contains, among the charger, a USB cable which allows you to update software. A carrying case serves as protection and for the transport. It cares for better readability of the display at sunshine.
Digital Spectrum Analyzer
LNB/Tuner input
F-type connector: IEC 169-24
Frequency range: 950 MHz ~ 2150 MHz
Input impedance: 75 Ohm
Input level: -80 dBm to -20 dBm
LNB power supply: 13/18 V, max. 400 mA
LNB control signal: 22 kHz
DiSEqC control: All version 1.0, 1.1, 1.2, USALS
Demodulator
Front-end-modul: QPSK
Symbol rate SCPC and MCPC: 1.5 Mbps to 45 Mbps
Spectral inversion: Auto conversion
System resource
Processor: 32 bit
SDRAM: 16 MByte
FLASH: 2 MByte
EEPROM: 8Kbyte
Video decoder
Data rate: Up to 15 Mbit/s
Resolution: 720 x 576 (PAL), 720 x 480 (NTSC)
Video format: PAL, NTSC, SECAM
Connectors
Serial data interface: USB (Type A)
Power supply
Supply voltage: 12.6 V
Li-oN battery: 1950 mA
Charger: 90 – 240 V
Supply voltage (charger): 175 - 250 V ~ 50/60 Hz
Dimensions
Length x width x height: 9.5 x 15.5 x 4.5 cm
Gross-weight: 600 gr.
Temperature
Operating temperature: 0 °C to +40 °C
Storage temperature: -40 °C to +65 °C
